The repair and maintenance methods for CNC Furniture Router are as follows:
Strictly follow the regulations for operation and strictly prohibit illegal operations.
Clean the accumulated dust on the dust screen of the electric cabinet fan with dry compressed air every week, blowing from the inside out. Increase cleaning frequency in workshops with too much dust.
Check the water volume of the vacuum pump in each shift. It is strictly prohibited to operate without water. Change the water once a month and add water until the water pipe above flows out.

If the machine is not used for a long time but the power is cut off, the vacuum pump should be drained of clean water and the water tank cleaned. And apply anti rust oil to the guide rail, gear rack, and other parts, and cover the machinery with a waterproof cloth.
Carefully inspect the sliding rails, racks, and limit switches at the starting point of the cutting machine for dirt and clean them immediately.
Check if the drive belts of the main saw and auxiliary saw motors can operate normally, check if the drive belts are loose, and if they are loose, tighten them.
Check whether the front, rear, left, and right racks of the band saw blade are normal.
Dust removal. Especially check if the dust on the main power box and internal cooling fan of the cutting machine is clean.
Anti pollution solution for dust boots.
Emergency stop power switch needs to be careful to avoid secondary damage.
Check the heat pipe radiators of each motor of the CNC Furniture Router for dust or dirt, and also check whether the working pressure of each pressure gauge is normal.