The automatic edge banding machine is mainly used for the edge banding of panel furniture. It has the advantages of high automation, high efficiency and high processing accuracy, so it is loved by many furniture factories, which can help them save a lot of time, but when using , We also have to do the daily maintenance of the equipment, so do you know how to do it? How much do you know about it? Let's take a look at it together, hoping to help everyone.
1. Cleaning after work
every day 10 minutes before work every day, the equipment in operation should be cleaned, mainly for the sundries, sidebands and dust inside the machine.
2. Regularly check the integrity and wear of the tool
You can judge the use of the tool according to the effect of the workpiece after processing, or you can regularly remove the dust cover of the tool for visual inspection according to the situation.

3. Check whether the lubricating oil is sufficient every day.
Visually check whether the lubricating oil in the lubricating oil tank is normal and whether the power signal is normal. Conventional lubricating oil cannot go below the level marking line. When the machine is turned on normally, the fuel pump power light will be on. If the oil pump has not been refueled for six consecutive years, it means that the pump body is not working or has problems, and needs to be checked and repaired.
4. Always keep the conveyor chain lubricated and add lithium-based grease
. When the conveyor belt of the edge banding machine is open, add lithium-based grease to the oil gun delivered with the automatic edge banding machine equipment, and align the oiler with the sealer. A row of grease nipples on the lower beam of the side machine are squeezed several times so that the lithium-based grease reaches the guide rail completely.
5. High-temperature grease needs to be added to the gluing tank, and the time is in weeks.
Specific operation method: when the gluing tank is normally opened, add high-temperature lubricating oil to the oil gun distributed by the automatic edge banding machine equipment, and drain the oil outlet. Align the grease nipple protruding from the base of the gluing tank, and squeeze it for several times, so that the high-temperature lubricating oil can completely reach the bearing inside the base of the gluing shaft to achieve lubrication.
6. Check the water in the triple-piece water cup after air intake
every day. Visually check the liquid level and height of the triple-piece water cup before leaving work every day. The function of the third cup in the triple-piece is to collect the moisture in the compressed air, and it needs to be discharged manually after accumulation.
Regarding the daily maintenance of the automatic edge banding machine , the above content has been summarized for you in detail. I believe that you will have a new understanding and understanding of this after reading it. If you want to know more, you can pay more attention to us. website, I hope it can help you.