The automatic CNC Router is a cost-effective equipment that can realize automatic positioning, punching, slotting, processing optimization and other functions. the service life? How much do you know about this? Next, Blue Elephant CNC will give you a detailed summary.
After a survey, it was found that 80% of customers did not clean the equipment well when using the equipment, but simply cleaned the equipment table, and other parts were not cleaned at all, which is impossible.
1. We need to do the following:
1. The countertops need to be cleaned in time after the operation panel furniture is processed.
2. Clean the slag around the guide rail of the guide rail machine.
3. Regularly clean the screw to prevent foreign objects from sticking to the screw. The screw determines the accuracy of the machine, so it needs to be cleaned regularly.

4. It has been said many times that dust will cause serious damage to the circuit boards in the cabinet, so it must be cleaned regularly.
2. The serious wear of the automatic CNC Router tool can be judged from the following aspects:
1. When the CNC Router is running normally, the tool will make a harsh sound;
2. Listening to the sound of the spindle, the spindle will have obvious abnormal sound;
3. During the cutting process of the CNC Router, there will be obvious vibration, and the main shaft of the machine tool will have obvious vibration;
4. After the CNC woodworking Router is finished, there will be a problem of the quality of the bottom cutting line.
3. Tool wear stage of automatic CNC Router:
Generally speaking, tool wear can be divided into three stages: initial wear, normal wear and sharp wear.
Initial wear stage: The main cause of tool wear is that the tool is not preheated when the Router starts cutting, resulting in the tool temperature being too low and not reaching the normal cutting temperature. The tool wear at this time is mainly abrasive wear, which has a great impact on the tool. Large, easy to cause tool chipping. This stage is a very dangerous stage. If not handled properly, it may directly lead to the failure of the tool.
When using the CNC Router, the tool is easy to break in the initial wear stage. In order to avoid the phenomenon of tool chipping, we need to run the tool, and the cutting temperature of the tool gradually increases to a reasonable temperature. The experiment shows that the tool life after running-in will increase by about 2 times.
The method of running-in is to reduce the feed rate by half while maintaining the reasonable use of the spindle speed, and the processing time is about 5 to 10 minutes. When processing soft materials, take a small value and a large value when processing hard metals.
After the initial wear period of the tool, the cutting temperature of the tool reaches a certain value, which is the main wear and diffusion wear, and its role is mainly to cause local spalling, so the wear is relatively small and relatively slow.
When the wear reaches a certain level, the tool will fail and enter a period of rapid wear. At this time, the above situation will occur, and the tool should be replaced.
If you want to extend the service life of the automatic CNC Router, the above points must be firmly grasped to ensure that the equipment and tools are not damaged, reduce the degree of tool wear, and regularly clean the equipment to ensure that the operation is not damaged.